How to Install Custom Golf Cart Floor Mats: Step-by-Step Guide

Quick Answer

Installing custom Dekomats floor mats takes about 15–20 minutes and requires only a flathead screwdriver, a vacuum, and the included Velcro strips. The key is to prep the floor thoroughly and press the mat firmly into place.

Installation Steps

1. Clean the Floor Pan: Remove the old mat or any debris. Vacuum and wipe down the entire floor area with a mild cleaner. Let it dry completely. Even a small grain of sand can prevent the Velcro from gripping. A spotless floor is essential for a secure hold.
2. Dry-Fit the Mat: Place the custom Dekomats mat onto the clean floor without peeling the Velcro backing. Adjust until it lines up with the pedal openings, seat base, and side edges. Mark the desired position with painter's tape if needed. Do not peel the adhesive yet. The mat should lie flat without wrinkles. If it does not, double-check that you ordered the correct model.
3. Apply Adhesive Velcro Strips: Peel the backing from the pre-cut Velcro strips included with the mat. Press them firmly onto the designated spots on the floor pan. Wait 30 seconds for the adhesive to bond. Press each strip with your thumb for 15 seconds. Skipping this step can cause the strip to lift later, especially in heat.
4. Press the Mat into Place: Lower the mat onto the Velcro strips, starting from one side and working across to avoid air bubbles. Press down firmly over the entire surface, paying extra attention to the edges. Do not drive the cart for 12 hours after installation. This gives the adhesive time to fully set.
5. Inspect and Enjoy: Check that the mat is flush with the floor, pedals move freely, and no edges are loose. If everything looks good, your installation is complete. Recheck the mat after the first full day of use. If you spot a raised edge, press it down again while the adhesive is still fresh.

Product Facts

• Custom Golf Cart Floor Mats - Astro | Dekomats™: Dekomats "Astro" Design is an outer space-themed hand-drawn doodle, tailored to your exact golf cart model. This means the Astro mat is not a universal cut; you select your cart model during ordering, so installation is about alignment, not trimming.

  

• Custom Golf Cart Floor Mats - Topo | Dekomats™: Dekomats "Topo" Design uses a topographic map pattern and is precision-crafted for EZGO, Club Car, Yamaha, ICON EV, or Advanced EV Golf Carts. The Topo mat's exact fit removes the guesswork of alignment; your installation step is simply to position it correctly over the floor pan.