Yamaha Drive G29 Rear Flip Seat Installation Guide

By GOLFCARTSTUFF.COM™ | Golf Cart Wheels, Tires, Lights | Published: 2026-10-28

Category: How-to Guides

Step-by-step instructions to install a RHOX Rhino rear flip seat kit on your Yamaha Drive G29 golf cart, with tips to avoid common mistakes.

Quick Answer

Installing a RHOX Rhino rear flip seat on your Yamaha Drive G29 is a straightforward upgrade that adds a secure rear seat and cargo bed. Follow these steps to complete the job in a few hours.

Why the RHOX Rhino Kit Works for the G29

The RHOX Rhino Rear Seat Kit is designed specifically for the Yamaha Drive G29 platform, meaning the mounting brackets align with the factory frame holes without modification. Its powder-coated steel frame supports up to 450 lbs, and the seat cushion flips forward to reveal a flat cargo deck. This dual-purpose design makes it ideal for both carrying passengers and hauling gear.

What You’ll Need Before Starting

Have a socket set (mostly 10mm and 13mm), a torque wrench, a drill with a 3/16-inch bit, and a friend to help lift the seat assembly. The kit includes all hardware and an instruction manual, but check that you have the correct cushion color option before opening the sealed bags.

Installation Steps

Remove the Existing Rear Body: Unbolt the rear body panel of your Yamaha Drive G29. There are six 10mm bolts along the rear edge and two inside the bag well. Lift the panel off and set it aside. Common mistake: Forgetting to disconnect the taillight harness if your cart has factory lights. Check for a taillight wire harness before pulling the body panel.
Attach the Mounting Brackets: Position the left and right brackets against the frame’s pre-drilled holes. Use the supplied 10mm bolts and washers but do not fully tighten yet. Common mistake: Overtightening before the brackets are aligned can strip the threads. Leave bolts snug but loose to allow adjustment.
Assemble the Seat Frame: Bolt the main crossbar and side supports together on the ground. Use the 13mm bolts for the hinge points. Lift the assembly onto the brackets and secure it with the pivot bolts. Common mistake: Installing the hinge bolts upside down can cause the seat to bind when flipping. Orient all hinge bolts with the nut on top for smooth operation.
Mount the Seat Bottom and Backrest: Slide the seat bottom onto the frame tabs and push the locking pins through. Attach the backrest with the included carriage bolts. Common mistake: Forgetting to align the cushion’s grab-strap slots with the frame’s release levers. Test the seat flip mechanism before final tightening.
Wire the Taillights (If Applicable): Route the kit’s light harness along the frame rail and connect it to your cart’s existing taillight pigtail. Use zip ties to secure the wire away from moving parts. Common mistake: Running the wire over the seat hinge pin, which can pinch and short the circuit. Run the harness below the hinge line, not across it.
Torque All Bolts and Test: Tighten every bolt to the spec listed in the manual (typically 18-20 ft-lbs for frame bolts). Flip the seat up and down several times to confirm smooth operation. Common mistake: Skipping the final torque check can lead to loose joints on bumpy terrain. Re-torque after the first 50 miles of use.

Product Details

Yamaha Drive (G29) Golf Cart Rear Flip Seat Kit | RHOX® Rhino: The RHOX Rhino Rear Seat Kit includes a powder-coated steel frame that converts from a rear seat to a cargo bed. This dual functionality means you can carry two passengers or a cooler, golf bag, and tools without needing a separate cargo box.
Yamaha Drive (G29) Golf Cart Rear Flip Seat Kit | RHOX® Rhino