How to Install E-Z-GO TXT LED Tail Lights 1996-2013

By GOLFCARTSTUFF.COM™ | Golf Cart Wheels, Tires, Lights | Published: 2026-10-20

Category: How-to Guides

Step-by-step guide to installing LED tail lights on an E-Z-GO TXT (1996-2013). Includes wiring tips, common mistakes, and what to check before you start.

Quick answer

To install LED tail lights on an E-Z-GO TXT (1996-2013), remove the old assemblies, connect the new LED units using the 3-pin Molex connectors (or cut/splice if needed), mount the lights, and test both running and brake functions before final reassembly.

Why choose LED tail lights for your TXT

LED tail lights are brighter and last longer than traditional incandescent bulbs. For an E-Z-GO TXT from 1996-2013, upgrading to LED improves visibility on the course or street, especially during dusk or low-light conditions.

The replacement assemblies come as a pair and include provisions for both running lights and brake/turn functions. They work with both gas and electric TXT models in that year range.

Installation steps

1. Disconnect the battery: Remove the negative battery cable to prevent any short circuits while working on the electrical system. A common mistake is leaving power on — a short can blow a fuse or damage the new lights.
2. Remove the old tail light assemblies: Unscrew the two screws holding each tail light housing to the rear body. Gently pull the housing away and disconnect the wiring harness from the back of the old light. If the old screws are rusted, use penetrating oil and a snug-fitting screwdriver to avoid stripping the heads.
3. Check the connector compatibility: Compare the 3-pin Molex connector on the new LED assembly with the harness connector on your TXT. If they match, simply plug them together. If not, cut off the old connector, strip the wires, and splice the new connector in using heat-shrink butt connectors. Many TXTs built after 2001 use a different harness pattern — splicing is safe if done with waterproof connectors.
4. Test the lights before mounting: Reconnect the battery temporarily. Turn on the headlights to check running lights, then press the brake pedal to verify brake light function. If one side doesn't light, swap the two wires at that connector. Incorrectly wired polarity is the #1 cause of a non-functional LED light — testing now saves rework later.
5. Mount the new assemblies: Align the new LED housing with the mounting holes on the rear body. Insert and tighten the screws firmly but avoid overtightening — the plastic housing can crack. Use a small dab of silicone grease on the screw threads to prevent future corrosion.
6. Secure the wiring and reconnect the battery: Tuck any excess wire behind the tail light or secure it with zip ties to the rear frame. Reconnect the battery negative cable. Re-test both running and brake functions. Loose wires can rub against the tire or frame and cause a short — make sure they're routed safely away from moving parts.
7. Do a final road test: Take the cart for a short drive and have a helper watch the tail lights under braking. Ensure both sides respond the same way. If one light flickers during bumps, check the connector is fully seated and the wire isn't strained.

Product spotlight

EZGO TXT LED Tail Light Replacement Assemblies 1996-2013: These LED tail light assemblies are designed for EZGO TXT 1996-2013, gas or electric, and use a 3-pin Molex connector. The 3-pin plug matches many factory harnesses, but if your cart uses a different connector, you'll need to cut and splice wires — plan for this before starting.
EZGO TXT LED Tail Light Replacement Assemblies 1996-2013