Club Car Precedent LED Light Kit Installation Guide

Quick answer

Installing a Club Car Precedent LED light kit is a straightforward DIY project that typically takes 1-2 hours. Choose a kit matched to your model year and power type, then follow the included wiring harness and mounting instructions.

Step-by-step installation process

1. Gather tools and prepare the cart: You'll need a socket set, screwdrivers, wire strippers, electrical tape, and a test light. Park the cart on a flat surface, turn off the ignition, and disconnect the negative battery cable (for electric models) or remove the key (for gas models) to prevent any electrical shorts. Always disconnect the battery before starting any electrical work.
2. Mount the headlight bar: Attach the LED headlight bar to the front bumper using the provided fasteners. Align it so the beam points straight ahead and slightly downward. Tighten the screws securely but avoid over-tightening, which could crack the plastic housing. Check the headlight alignment before tightening fully.
3. Mount the tail lights: Position the tail lights on the rear of the cart, typically on the fender or body. Use the included brackets or screws. Ensure the wiring exits cleanly and won't be pinched by moving parts. Route wiring away from hinges and suspension components.
4. Run the wiring harness: Lay the wiring sub-harness along the frame, securing it with zip ties. For electric models, use the bucket harness; for gas models, use the gas harness. Avoid routing wires near hot engine parts or sharp edges. Leave a little slack at connection points to prevent strain.
5. Connect the power and switch: Connect the harness to the battery (or an existing 12V source) using the in-line fuse. Mount the push-pull switch in the dash or under the seat, within easy reach. Connect the switch to the harness according to the wiring diagram. Double-check the fuse rating and connection polarity before powering up.
6. Test the lights: Reconnect the battery, turn on the switch, and check both headlights and tail lights. If a light doesn't work, inspect the connections and fuses. Adjust the headlight aim if necessary. Test all functions before putting the cart back into service.

Products mentioned in this guide

• Club Car Precedent Basic LED Light Kit- Instamatic®: The Club Car Precedent Basic LED Light Kit includes an LED headlight bar, two LED tail lights, wiring sub-harness, in-line fuse, and push-pull switch. It fits Precedent models newer than mid-2008 and includes separate harnesses for electric and gas models. This kit is a budget-friendly option that covers all the essentials, and the separate harnesses ensure a proper fit for your specific power type.

  

• Club Car Precedent 12V Light Kit (Choose Basic or Deluxe!) | Steeleng: The Steeleng Precedent 12V Light Kit includes high-intensity LED headlights and tail lights in a rugged injection-molded plastic housing, and you can choose between basic and deluxe packages. If you want a step up in durability and brightness, this kit offers a choice between basic and deluxe, so you can pick the level of features you need.